Car, HYUNDAI, General, H-1, IMAX, ILOAD, GRAND STAREX (TQ), 2016, G 2.4 DOHC, Automatic transmission (AT)

Transaxle - Automatic transmission (AT) - 0

Identification

Repairshop or tester serial number: --

Calibration program date: --

Supplier ECU - hardware number: --

Repair shop code or tester serial number: --

Field reprograming date: --

Software version bootloader: --

ECU - software version number: --

Calibration number: --

Supplier ECU - hardware number: --

Calibration repair shop or tester serial number: --

Calibration program date: --

Software version bootloader: --

Software version number: --

Sub system calibration number: --

Vehicle manufacturer ECU hardware number: --

Supplier ECU - hardware number: --

Repairshop or tester serial number:: --

Programming date: --

DTC

Controls

Clear DTC

Data stream

Engine speed: -- rpm

Vehicle speed: -- km/h

Throttle position sensor: -- %

Input shaft speed: -- rpm

Output shaft - speed: -- rpm

Damper clutch - slip: -- rpm

Oil temperature: -- °C

Gear transmission ratio: --

Shift position: --

Selector lever position switch: --

Overdrive off switch: --

Brake pedal switch: --

Lock-up: --

Gear position (next): --

MIL: --

Number of DTC: --

Battery voltage: -- V

Engine torque: -- %

High oil temperature mode: --

Up hill mode: --

Down hill mode: --

Shift solenoid valve 1/A: --

Shift lock solenoid - commanded signal: --

Shift solenoid valve 2/B: --

Shift control solenoid valve 1 - feedback signal: --

Shift lock solenoid - feedback signal: --

Shift control solenoid valve 2 - feedback signal: --

Line pressure control solenoid - current (SLT): -- mA

Line pressure control solenoid - feedback current (SLT): -- mA

Emergency mode: --

Check engine telltale: --

A/T telltale: --

Overdrive telltale: --

Actuators test

Controls

Clear learning value

Shift Solenoid #1 (S1)

Shift Solenoid #2 (S2)

Lock Up Solenoid

SLT current (Linear solenoid valve-Load)

O/D Lamp

Check engine telltale

SVS (A/T warning lamp) (n/a)

Utility

Controls

Resetting Auto T/A Values